Table of Contents
Advertisement
3. Remote Control handset (LP-119) :
First to install Battery and press PANIC button, the led will light on for 1 Sec,
The sensor will be learned into main console.
4. Panic Watch (LP-117) :
First to install Battery and press RED button, the led will light on for 1 Sec, The
sensor will be learned into main console.
5. Smoke Detector (LP-118) :
First to install Battery and press S1 button, the led will light on for 1 Sec, The
sensor will be learned into main console.
6. Gas Detector (LP-125) :
Plug the AC power and press the TEST button, the led will light on for 2 Sec,
The sensor will be learned into main console.
7. When the sensor is learned into main console, It will show the message as below.
At the time it will automatically switch to next sensor learning mode
8. If the sensor has been learned in main console. Main console will show the sensor
has been learned in memory and not allow same sensor to learn into main
console.
9. If sensors have learned and reach 63 zone numbers, LCD panel shows memory
full message.
NOTE:1. Sensors belong to 24 hours included:
Smoke Detector (LP-118), Gas Detector (LP-125), Panic Watch (LP-117)
Remote Control Handset (LP-119 PANIC button) and Main Console HELP
button.
2. Distinguish A-AWAY and H-HOME mode:
When system is armed in HOME mode, Main Console will neglect the
transmission signal from the PIR(LP-120).
2. OVR
: To overlay the sensor. (when sensor is no good or replacement)
To replace the original sensor, only need to key-in sensor learned order
number. Finish the number key-in and press ENTER , system will ask
for relearning the Sensor, you can trigger the sensor and learn the sensor
into the main console.
STORAGE
SENSOR
IN
MEMORY
Learning :
Sequent
Trigger
Sensor
WARNING !!
Sensor in memory
Learning : Sequent
Memory Full
12
02
63
Advertisement
Table of Contents
