Laipac LP-1500 Owner's Manual page 20

4. BATTERY : Remove the Battery cover and insert one 9V alkaline battery.
5. ROCKET ARM & HOLDER : For mounting on the wall.
6. BATTERY COVER
Replace the Battery
When the sensor send the low battery voltage signal to main console. Please
replace a new battery for the sensor. In the main console, the LCD display shown
the message as below
Zone Address Setting
Enter the Installer password and the main console is in learning mode, after installing the
battery on the PIR. Set the power switch from " OFF " to " C " position. In the PIR panel,
The red LED will blink for 1 sec, It means to transmit out a signal for 1 sec or to activate
PIR sensor by detecting people pass by, then the Main Console emits one 'Beep' and LCD
displays 'In Memory', it means the PIR has learned into the system successfully.
When main console is in armed mode, If PIR detects the movement of human or
animals (cat, dog), it will leave message on the LCD display as below.
Notes on the Position when Install
Motion sensors detect the movement of humans and animals within their range. In order
to prevent false alarms, we recommend that you do not install any motion sensor in the
following areas:
Do not install any motion sensor in the following areas:
Where there is a device that causes rapid temperature change or rapid heat
transfer. for instance, near an air conditioner, fire place, heater or other
intermittent heat sources.
Where the sensor will be exposed to direct sunlight.
Near large electrical devices and/or high output radio frequency sources, like the
refrigerator, microwaves computers, and light dimmers.
Where the effective range of the sensor is covered or blocked by furniture.
Where pets enter and exit freely, for instance - a cat or dog door.
Directly opposite any large object with flat reflecting properties, like large
windows or mirrors.
In a bathroom or other area that is exposed to moisture and extreme temperature
change.
sensitivity.
63 PIR SENSOR
01 Low battery
63 PIR SENSOR
01 Zone
19