Panic Alert Function; Arm Or Disarm Via The Telephone Line - Laipac LP-1500 Owner's Manual

Check :
0 – T : To review (1- Exit) Exit time, (2-Alarm) Alarm time, (3- Entry) Entry time.
123456 – P : To review phone number sets.
7-MSG : To review recorded message (Press number key will play back the recorded
message).
8-DIAL : To review dial mode
*- CODE : To review the setting for Central Monitoring. (The program will be designed
for Central Monitoring use in future, the function is not available at the
moment).

Panic Alert Function

Press and hold SPEED DIAL button and assigned button, Main console will
automatically execute the autodial and alarm, if you want to cancel the autodial and
alarm when they are activated, Please key-in the Master password to cancel them..
SPEED DIAL + 4 , the autodial order is: phone 4
phone 3 (Intruder happened condition)
SPEED DIAL + 5 , the autodial order is: phone 5
phone 3 (Fire happened condition)
SPEED DIAL + 6 , the autodial order is: phone 6
phone 3 (Medical help happened condition)

Arm or Disarm Via the Telephone Line

This function allows you to dial your home telephone from outside to Arm or Disarm your
security system. When hear a long 'Beep' sounds after 10 rings in the phone, then entry
'Master code'135246 (default) if the password is correct, it will respond a long Beep
sounds in the phone then to respond the system status at this moment(if the password is
less than 6 digits, need to use #
button to finish the password entry). One 'Beep' sound means in 'Armed-Away', two 'Beep'
sound means in 'Armed-Home' and three 'Beep' sound means in 'Disarm'. At this moment
you can key-in (1, 2, 3 or 4). Main console will respond the relative message.
Respond message as below:
Press 1 means in 'Armed-Away' and in the phone will hear one 'Beep' sound.
Press 2 means in 'Armed-Home' and in the phone will hear two 'Beep' sound .
Press 3 means in 'Disarm' and in the phone will hear three 'Beep' sound.
Press 4 will switch to telephone communication mode.
Press 0 will end the telephone communication.
If the system has been programmed in 'Armed-Away' or 'Armed-Home' status
previously, you need to 'Disarm' it first to reset the status. If you do not disarm
first, and press '1' or '2' directly, the system will emit 'bi-bi-bi' to reject your
setting. So press '3' to disarm it.
phone 1
phone 1
phone 1
15
phone 2
phone 2
phone 2