Table of Contents
Advertisement
Reset the System ( Refer to above picture)
You can press the SW3 reset button to let password ( Install, Master )
and timer ( exit, alarm, entry time ) go back to defaults.
LP-120 PIR Motion Detector
The PIR Motion Detector is designed to detect the movement of object in rooms or hallway.
The effective range of the motion sensor is 30 feet long, and with an 84 degree horizontal
angle.
Before using the sensor, the sensor needed to be learned into main console. If main
console is armed in HOME mode. Even if PIR Triggered, the main console will neglect the
PIR signal.
Main Features :
1. LED : When PIR has detected any moving of human. The red LED will blink for one
sec. it means to transmit out a signal to Main Console.
When the battery power is down to low level, It will send out a low voltage signal.
The red LED will blink for one sec. If Main Console receive the signal, will leave
some message on the display.
2. C/OFF/W SWITCH :
When the switch is set on "C – Continue" position, the PIR continually
detects at interval every 3 to 5 seconds after detecting the movement of
human (dog ,cat).It is an idea for checking
When the switch is set on " OFF" position, It will turn off the power, the PIR
does not detect at all.
When the switch is set on "W- Wait" position, the PIR detects at every 2
minutes to 3 minutes after detecting the movement of human ( dog, cat).
" W " position set mode will save the power.
3. DETECTING SENSITIVITY : (1 , 2 , 4) select the sensor to high , medium or low
18
Advertisement
Table of Contents
