Table of Contents
Advertisement
Zone address setting
You can set the sensor (LP-122/LP-123) as " Door " or " Window " detector by using the
jumper selector and follow the marked. Ex. You want to set the sensor as Door sensor, put
the Jumper on marked "D" side. (If set Jumper on marked "W" side, the sensor becomes
as Window sensor).
LP-122 DOOR / WINDOW
SELECT
TYPE SEL
JUMPER
DOOR
WINDOW
Notes on the Door/Window Detector
1. The LED on the sensor will flash once when the sensor is triggered.
2. There cannot be a gap greater than 1/4 inch (5 mm) between the magnet sensor and
the magnet, otherwise, the sensor will not work properly.
Enter the installer password and let main console in learning mode. take magnet away
from magnet sensor, it will trigger the sensor and LED will light on for 1 sec. the Main
Console emits one 'Beep' and LCD displays 'In Memory', it means sensor has learned into
the system successfully.
LCD display on the Main Console for LP-122/123
When system is in armed mode. (message shown on main console)
Window opened
63
WINDOW
01 Open
When system is in disarm mode. (message shown on main console)
Window closed
63
WINDOW
01 Close
Door opened
SENSOR
63
SENSOR
22
LP-123 DOOR / WINDOW
SELECT
TYPE SEL
DOOR
SENSOR
01 Open
JUMPER
DOOR
WINDOW
Advertisement
Table of Contents
