Wiring The Gas Heat Device; Figure 133 - Gas Burner Component Locations; Figure 134 - Main Power And Control Panel With Cover Open - Pace PAI Installation And Assembly Manual

SECTION 3 - HANDLING, STORAGE, AND INSTALLATION

WIRING THE GAS HEAT DEVICE

It is the installer's responsibility to wire this device, if
the single point power connection was not purchased.
Panel locations and sizes vary based upon the AHU's
size and burner configurations. Burner voltage is se-
lected to match the primary AHU voltage. Modulation
control voltage 2-10 VDC is standard.
MAIN POWER AND CONTROL
TERMINATION PANEL
INSIDE GAS
BURNER PIPE
CHASE

Figure 133 - Gas Burner Component Locations

Form PA102.20-N1
Electrical penetrations can come through the floor or
side wall panels. Drill and properly seal any penetra-
tions to keep out moisture. Refer to the service manual
for more information.
Make power connections per the wiring diagrams pro-
vided on the inside of the burner control panel. Refer
to the Air Handling Units - Operation and Maintenance
Manual (Form PA102.20-OM2) for more information.
Figure 134 - Main Power and Control Panel with
Cover Open
FLUE CONNECTOR
ID FAN
ID FAN MOTOR
BURNER CONTROL
PANEL
79
Installation & Assembly Manual │ PACE
LD11597
DRAFT DAMPER
ADJUSTABLE
QUADRANT
LD11596b
Issue Date: 07/03/2018
3