Available Coil Arrangements; Figure 167 - Non-Stacked Coil Design (Special Quote); Figure 168 - Non-Stacked Coil Design (Standard) - Pace PAI Installation And Assembly Manual

SECTION 3 - HANDLING, STORAGE, AND INSTALLATION

Available Coil Arrangements

Figure 168 on page 103 through Figure 170 on page
104 illustrate the available coil arrangements. Con-
tact the PACE coil marketing group for other arrange-
ments not shown.
Configure face-split DX coils to provide full-face cover-
age at all condensing AHU load steps. PACE assumes
no responsibility for compressor failure, if full face cov-
erage is not applied. Consult the PACE factory if ap-
plication assistance is needed to convert the split face
to a full face operation.
D2
D3
D1
3 Distributor
Circuits Row
Split 66-33 Split
SQ Required

Figure 167 - Non-Stacked Coil Design (Special Quote)

Form PA102.20-N1
D2
H2
D1
H1
2 Distributor
Circuits Face Split
D2
H2
H1
D4
D1
D4
H4
D3
H3
D3
4 Distributor
Circuits Face Split
50-50% Interlaced
SQ Required
H1
D1
1 Distributor
Circuit

Figure 168 - Non-Stacked Coil Design (Standard)

H2
H1
D1 D2
2 Distributor
Circuits Row Split
H3
H1
D6
D5
D2
D8
D1
D7
H2
H4
4 Distributor
Circuits Row Split
Interlaced SQ
Required
103
Installation & Assembly Manual │ PACE
H2
H1
D2
D1
2 Distributor
Circuits 50 -50%
Interlaced
LD09143a
H6 H5
H2 H1
D2
D1
H8 H7 H4 H3
D4
D3
8 Distributor
Circuits Row Split
& Face Interlaced
SQ Required
LD09144a
Issue Date: 07/03/2018
3