Assembling The End Channel Shipping Split; Figure 48 - Assembling The End Channel Shipping Split With Energy Recovery Wheel - Pace PAI Installation And Assembly Manual

PACE │ Installation & Assembly Manual
Assembling the End Channel Shipping
Split
The assembly is the same regard-
less which sections are connected
together.
Use the following instructions to prepare the sections
before they are attached.
1. Remove the shipping brackets in the corners.
2. Clean the metal surface where gasket is to be ap-
plied with mineral denatured alcohol or rubbing
alcohol.
3. Apply the neoprene gasket to all raceway mating
surfaces of each section. On large AHUs, install
two gaskets side by side on the intermediate race-
way surfaces.
4. Make sure that the sections are not racked, and
will line up properly.
BASE RAIL
SUPPORT
PLATE

Figure 48 - Assembling the End Channel Shipping Split with Energy Recovery Wheel

Issue Date: 07/03/2018
SHIPPING
BRACKETS
SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
5. Attach the sections as follows:
a. Make sure assembly surface is clean and
level to allow the sections to slide freely. If
the surface is irregular, use metal shims un-
der sections as necessary to align mating
surfaces.
b. Pull the sections together using a come-a-
long, drawing the base together.
c. Attach the sides of the sections. Beginning
at the bottom of the sections, secure the end
channel assembly brackets together using
fastener pack (P/N 386-03419-000) at each
bracket. Continue securing the end channel
assembly brackets together, working from
bottom to top, pulling the sections tight.
d. After the sides are secured, secure the
brackets on top of the AHU with the same
hardware removed in Step 4.
END SPLIT
MOUNTING
BRACKET
40
HEAT WHEEL
SEGMENT
FASTENER PACK
(P/N 386-03419-000)
INTERMEDIATE
RACEWAY
NEOPRENE
GASKET
LD14262
Form PA102.20-N1