Figure 39 - Remove And Reposition Shipping Split Angle; Figure 40 - Bring Shipping Splits Together; Figure 41 - Fasten Bottom Lifting Lugs - Pace PAI Installation And Assembly Manual

SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
Figure 39 - Remove and Reposition Shipping Split
Angle
8. Attach the come-a-longs to the far end of the first
section.
9. Start pulling the sections together. Pull evenly on
both sides.
a. Make sure all electrical or control wires or
tubes are clear.
b. Guide the top raceways together by plac-
ing rods or drift pins through the holes in the
top guide angles. When the raceways are
together, install the long bolts provided as
shown in Figure 40 on page 37.

Figure 40 - Bring Shipping Splits Together

Form PA102.20-N1
LD14097
SHIPPING-
SPLIT
LD13775
c. Guide the bottom raceway/base rails togeth-
er, using rods or drift pins through the holes
in the lifting lugs on opposite sections simul-
taneously.
d. If there is any difficulty aligning the sections,
due to racking of one section or the other,
use a come-a-long diagonally on the inside
of that section at the shipping split or across
the tops of the opposite sections.
e. If there is any difficulty aligning the sections
due to the top and bottom not pulling together
simultaneously, apply shims under the sec-
tions as needed to compensate for uneven
placement area.
10. Complete pulling the sections together, using the
come-a-longs. The bolts hold the sections tight af-
ter they are pulled together.
11. Fasten the bottom lifting lugs together with the 1/2
in. x 5-1/2 in. bolts in fastener packet (P/N 386-
03418-000) as shown in Figure 41 on page 37.
12. Fasten the top raceway bracket with the 1/2 in. x
5-1/2 in. bolts in fastener packet (P/N 386-03418-
000).
BOTTOM
LIFTING
LUGS

Figure 41 - Fasten Bottom Lifting Lugs

13. Apply neoprene gasket (P/N 028-15954-010) to
the underside of the seam caps, and install them
over the joints with hex head screws (P/N 386-
04747-000) as shown in Figure 29 on page 33.
Apply painted seam caps over the joints on the
sides and roof of the exterior, and apply galva-
nized seam caps on the interior floor only.
If a roof seam cap has a tab on one
end only, the end without the tab goes
above the pipe chase location.
37
Installation & Assembly Manual │ PACE
LD13781
Issue Date: 07/03/2018
3