Figure 87 - Position Pre-Filter In Front Of Final Filter; Figure 88 - Spring End Of Latch; Figure 89 - Completed Assembly - Pace PAI Installation And Assembly Manual

SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
3. Place the pre-filter against the face of the Multi-
Cell SBM DH filter. The pre-filter latches may have
to be re-positioned as shown in Figure 87 on page
55, to allow the proper placement of the pre-
filter.

Figure 87 - Position Pre-Filter in Front of Final Filter

4. Grasp the end of the pre-filter latch and spring
it, so that it fits over the edge of the pre-filter as
shown in Figure 88 on page 55.
5. Repeat this step with the remaining latches.

Figure 88 - Spring End of Latch

Form PA102.20-N1
After placing all remaining pre-filter latches around the
pre-filter; the finished assembly should look like the
one shown in Figure 89 on page 55.
LD10165

Figure 89 - Completed Assembly

LD10190
55
Installation & Assembly Manual │ PACE
Issue Date: 07/03/2018
3
LD10167