Disassembly With The Integrated Drill Drift B34H / B34Hv - Optimum Optidrill B 34H Operating Manual

5.8.3

Disassembly with the integrated drill drift B34H / B34HV

ATTENTION!
The tool and/or the drill chuck will fall down. Hold
the tool or the drill chuck while drifting it out.
3
ATTENTION!
Do not try to expel the tool when it is in the
intermediate position. This might cause damages
of the integrated drill drift or of the feed handle.
With the below described procedure the taper mandrel
is being loosened from the drilling spindle.

Move the sleeve as far down until the locking pin
can be moved a little bit (Img. 4-16 (b) interme-
1
diate position).

Move the locking pin
engages completely (Img. 4-16 (c) expulsion posi-
tion).

Press the sleeve lever
 The taper mandrel is pressed out of the drill spindle.
a)home position
GB B34H | B34HV
104
so far, until the locking pin
1
with a fast and powerful movement upwards.
2
b) intermediate position
Abb.5-15: Functional diagram of the drill drift (sectional view)
Translation of the original instructions
1
3
Abb.5-14: Disassembly B34H / B34HV
c) expulsion position
2
Operation
Version 1.1.3 - 2020-07-21