Table of Contents
Advertisement
Available languages
Available languages
5.7
Speed change
WARNING!
Danger due to drill chuck or tools flying off at high speed. Make sure not to exceed the
maximum speed of the drill chuck when setting the spindle speed.
Switch off the machine by pressing the main switch.
the protective cover.
Open
Loosen the lever of the V-belt tensioning.
Position the V-belt respectively on the required transmission stage.
Tighten the clamping lever again and
thus tighten the belt drive.
Close the protective cover.
Operation
Version 1.1.3 - 2020-07-21
V-belt
Lever V-belt tensioning
Abb.5-8:
Lever for the V-belt tension B34 H/ B34 H Vario
Abb.5-9:
Lever V-belt tensioning
Translation of the original instructions
TENSIONED
RELEASED
B34H | B34HV
GB
101
Advertisement
Table of Contents
