Operation Guide; Continuous Wave Signal - Saluki S1132 Series User Manual

This chapter introduces the function and usage of the S1132 signal generator through examples. The contents of
this chapter are as follows:

Continuous Wave Signal


Sweep Signal

Analog Modulation Signal

Digital Modulation Signal

Pulse Modulation

LF Signal

Up-conversion Function

Power Measurement

3.1 Continuous Wave Signal
The most common output signal of a signal generator is the continuous wave limit signal. In the following example,
we use Agilent N9020A spectrum analyzer to measure the CW output signal information of S1132 signal generator
(with frequency of 1GHz, amplitude of -10dBm).
Operation steps:
1. Instrument connection
Use a coaxial cable to connect the signal output end of the signal generator to the RF input port of the N9020A
spectrum analyzer.
2. Parameter setting
(1) Reset the signal generator
— Press【Preset】
(2) Parameter setting
— Press【FREQ】
— Press【AMPT】

3 Operation Guide

button
button, input 1 GHz
button, input -10 dBm
Tel: 886. 909 602 109
10
Email: sales@salukitec.com
www.salukitec.com