Typical Operation; Prepare; Continuous Wave Output - Saluki S1131 User Manual

5 Typical Operation

This chapter will show how to use S1131 Signal Generator, following functions are included:

Continuous wave output


Step sweep output

List sweep output

AM signal output

Digital modulation signal output

LF internal modulation source output


5.1 Prepare

Press the power button to turn on S1131 signal generator.
This chapter means to show the basic operations of S1131 Signal Generator. Spectrum analyzer is used to simulate the receiver.
In this menu, S3331B spectrum analyzer is used for signal analysis. For operation of S3331B please refer to document S3331-
03-02 ( S3331 series spectrum analyzer user manual).
Before any test, please ensure damage level of the spectrum analyzer to avoid any damaged.
5.2 Continuous Wave Output
This case will show how to set S1131 signal generator to generate a 100MHz, -10dBm continuous sine signal.
1) Connect S1131 to S3331 via a N type cable.
2) Preset the S1131, S3331
Press【PRESET】 key . The instrument will return to default settings.

3) Frequency settings
Press 【FREQ】 key..

Use number keys, knob or up/down arrow key to set the center frequency to 100MHz

4) Amplitude settings
Press【AMPTD】key .

Use number keys, knob or up/down arrow key to set amplitude to -10dBm.

5) Press 【RF】to enable the output. The 【RF】lights.
6) Set the S3331 accordingly. Please see following screenshot
Tel: 886.2.2175 2930 Email: sales@salukitec.com
13
www.salukitec.com