Saluki S1132 Series User Manual page 29

2. Parameter setting
(1) Reset the signal generator
— Press【Preset】
(2) Parameter setting
— Press【AuxFctn】
— Select [LF OUT]
— Select [Wave]
— Select [Square]
— Select [Freq], input 20 kHz
— Select [AMPL], input 1 Vpp
— Press【LF】
3. Test result
After setting the relevant parameters of the oscilloscope, the result is shown in Figure 3-12.
button
button
button, make the【LF】button backlight bright
Figure 3-12 Test result of the square wave signal
Tel: 886. 909 602 109
29
Email: sales@salukitec.com
www.salukitec.com