Table of Contents
Advertisement
3.6.3 Triangle wave
For example: to output LF signal with frequency of 100kHz and amplitude of 1Vpp.
Operation steps:
1. Instrument connection
Use a coaxial cable to connect the LF output port of the signal generator to the channel 1 input end of the
MSO-X2020A oscilloscope.
2. Parameter setting
(1) Reset the signal generator
— Press【Preset】
(2) Parameter setting
— Press【AuxFctn】
— Select [LF OUT]
— Select [Wave]
— Select [Triangle]
— Select [Freq], input 100 kHz
— Select [AMPL], input 1 Vpp
— Press【LF】
3. Test result
After setting the relevant parameters of the oscilloscope, the result is shown in Figure 3-13.
button
button
button, make the【LF】button backlight bright
Tel: 886. 909 602 109
30
Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
