Bus And Port Connections; Overview - Honeywell CIPer 50 Installation & Commissioning Instructions

Bus and Port Connections

Overview

WARNING
Risk of electric shock or equipment damage
• Do not touch any live parts in the cabinet.
• Disconnect the power supply before making connections to or removing connections from
terminals of the CIPer Model 50 controller or Panel Bus I/O modules.
• Do not reconnect the power supply until you have completed installation.
• Due to the risk of short-circuiting (see Figure 24), it is strongly recommended that the CIPer Model
50 controller be supplied with power from a dedicated transformer. However, if the CIPer Model 50
controller is to be supplied by the same transformer powering other controllers or devices (e.g., the
PW M-Bus Adapter), care must be taken to ensure that correct polarity is observed.
• Observe the rules regarding electrostatic discharge.
CIPer MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
TM
1 2 3 4 5
2 1
24 25 26
RS485-1
1 2
9
Figure 2: Top view (with HMI and full complement of onboard I/Os)
1 2
3 4
6
27 28 29 30 31 32 33 34 35 36 37 38 39
5 6 7 8 9 10 11 12 13 14 15 16 17 18
Figure 3: Side view
11
7 8
40 41 42 43 44 45 46 47
19 20 21 22 23
31-00233-02