Hitachi ZX200-5G Workshop Manual page 420

Assembly of Center Joint
IMPORTANT: Before assembling, apply hydraulic oil
onto parts in order to prevent them from seizing.
IMPORTANT: When assembling the seals, apply
grease (Apolloil Autorex C) and install seals to
each groove.
IMPORTANT: If bushing (05) has been removed,
install bushing (05) first. (Refer to W4-3-2-6.)
1. Install dust seal (02) to spindle (00A) with lip part (a)
of dust seal (02) facing to body (01) side.
a
a - Lip Part
2. Install O-ring (03) and oil seals (04) (6 used) to body
(01).
SECTION 4 UNDERCARRIAGE
Group 3 Center Joint
02
01
W178-03-03-002
W4-3-2-4
IMPORTANT: Do not damage bushing (05).
IMPORTANT: The clearance between body (01) and
spindle (00A) is approximately 0.1 mm. Insert
body (01) along axis straight and slowly. Do not
damage the seal.
IMPORTANT: Do not make a step on ring (06)
mounting part (b).
3. Place spindle (00A) on a workbench. Fit the
matching marks made when disassembling and
install body (01) to spindle (00A).
b
b - Ring (06) Mounting Part
00A
W800-03-03-002
01