Hitachi ZX200-5G Workshop Manual page 404

10. Install balls (09) (2 used) to housing (00).
11. Apply grease onto the ball (09) hole of swash plate
(18). Fit the position of balls (09) (2 used) and install
swash plate (18) to housing (00).
d
CAUTION: The housing (00) assembly weight: 59
kg (135 lb)
12. Attach a nylon sling onto housing (00). Hoist the
housing (00) assembly. Place the housing (00)
assembly horizontally with the brake releasing oil
passage (a) down.
f
NOTE: If housing (00) is placed with brake releasing oil
passage (a) topside, the thick part of swash plate (18)
becomes topside. If placing housing (00) horizontally,
swash plate (18) may suddenly come out.
a
a - Brake Releasing Oil Passage
SECTION 4 UNDERCARRIAGE
Group 2 Travel Device
WDAA-04-02-008
W4-2-3-6
IMPORTANT: Install retainer (16) with the chamfered
side facing to the bushing (17) side.
13. Install springs (19) (6 used), bushing (17), retainer
(16), and plungers (14) (9 used) to rotor (21).
b
b - Chamfered Side
14. Install the rotor (21) assembly to housing (00).
d
CAUTION: The housing (00) assembly weight: 67
kg (150 lb)
15. Attach a nylon sling onto housing (00). Hoist the
housing (00) assembly. Place the housing (00)
assembly with the brake valve (32) mounting
surface up.
IMPORTANT: Check the installation order of friction
plate (22) and plate (23).
16. Install friction plates (22) (4 used) and plates (23) (4
used) to housing (00).
17. Apply grease onto O-rings (28, 26). Install O-rings
(28, 26) to brake piston (25).
16
17
W178-02-11-225