Hitachi ZX200-5G Workshop Manual page 396

d
CAUTION: Ring gear (20) weight: 39 kg (86 lb)
26. Install eyebolts (M12, Pitch 1.75 mm) (2 used) to the
bolt, washer (43) holes (2 places) of ring gear (20).
Attach nylon slings onto the eyebolts. Hoist ring
gear (20). Install ring gear (20) to drum (04) with
bolts (21) (24 used).
j : 24 mm
m : 270 N·m (27 kgf·m, 200 lbf·ft)
27. Install sun gear (18) to third stage carrier (12) with
the thinner diameter part up.
28. Install spacer (24) to second stage carrier (23).
29. Install needle bearing (26) to planetary gear (25).
30. Secure planetary gear (25) between thrust plates
(27) (2 used). Install them to second stage carrier
(23).
31. Install pin (28) to second stage carrier (23). At this
time, fit the spring pin (29) hole of second stage
carrier (23) and the pin (28) hole.
32. Install spring pin (29) to second stage carrier (23)
with the slit (a) side facing to the cover (41) side.
28
a - Slit
33. Install other planetary gears (25) (2 used) to second
stage carrier (23) in the same way as steps 29 to 32.
SECTION 4 UNDERCARRIAGE
Group 2 Travel Device
29
a
W178-02-11-210
W4-2-2-10
34. Install the second stage carrier (23) assembly to ring
gear (20).
35. Install sun gear (30) to second stage carrier (23) with
the thinner diameter part up.
36. Install spacer (33) to first stage carrier (32).
37. Install needle bearing (35) to planetary gear (34).
38. Secure planetary gear (34) between thrust plates
(36) (2 used). Install them to first stage carrier (32).
39. Install pin (37) to first stage carrier (32). At this time,
fit the spring pin (38) hole of first stage carrier (32)
and the pin (37) hole.
40. Install spring pin (38) to first stage carrier (32) with
the slit (b) side facing to the cover (41) side.
37
b - Slit
41. Install other planetary gears (34) (2 used) to first
stage carrier (32) in the same way as steps 37 to 40.
38
b
W178-02-11-210