Install The Wheels; Insert The Seatpost And Seatpost Collar - Argon 18 E-119 Manual

16.

Install the wheels

1. Remove both axle protectors.
2. Remove both brake pad spacers.
3. Apply grease to the axle threads.
4. Place the rear wheel in the frame.
5. Thread the thru-axle through the wheel
and tighten it to 10 Nm.
6. Repeat for front wheel.
7. Apply pressure on both brake levers.
8. Make sure wheels are turning freely
and the discs don't rub. If they do,
adjust the caliper position.
2 3 3 4
HT 3 Nm HT 1 Nm
10 4
2.5
2.5
35 Nm 9 Nm HT-2
8 5
2.5 2.5
HT HT 4 Nm HT
3 3
2.5 2.5
40 Nm
4 Nm
4Nm 6 Nm
T25
T25
8
2 Nm 7 Nm 10 Nm HT-5
3 4
6
2.5
5 Nm 2 Nm
3
2.5
17.

Insert the seatpost and seatpost collar

6 Nm
4
2 Nm
2
HT
10
35 Nm
8
HT
3
40 Nm
1. Plug in the Di2 battery if using a Di2 build.
2. Set the seatpost to the desired height (where you marked your height
while disassembling).
3. Tighten the M8 x 10mm set screw on the seat post clamp to 5.5 Nm.
2 Nm
3
IMPORTANT:
Refer to p.16 of the assembly guide for seat post MIN and
MAX insertion values.
reassembly
12 Nm 5.5 Nm HT-1/4
5 4 2
3 Nm HT 3 Nm
3 3 4
3 Nm HT 1 Nm
4
2.5 2.5
9 Nm HT-2
5
2.5 2.5
HT 4 Nm HT
3
2.5 2.5
4 Nm 6 Nm 4Nm
T25
T25
8
7 Nm 10 Nm
HT-5
4
6 2.5
5 Nm 2 Nm
3
2.5
E-119TRI+DISC: travel guide
11