Table of Contents
Advertisement
Mounting Sensors
The Headsight sensor will not fit on the outer two snouts. Install
the outer sensors on the second row from each end.
Inner Rows
1. Choose the rows on which to mount the sensors.
•
Outer sensors should be set one row in
•
Center sensor should be on the middle row
2. Lay out wiring to appropriate snout shown in next section.
•
Wiring will run from the sensor to the rear of the header near the combine's feederhouse connection
•
Choose extension harness for each snout according to the table below
3. Bolt the sensor to the bracket as shown.
•
The mounting flanges must be to the back
•
M 8 carriage and flange nut on front bolt
•
M 8 x 10 Flange bolt in rear hole
4. Drill a 1¼" hole in the rear corner of the front pocket
as shown.
02
Advertisement
Table of Contents
