Install Horizon Or Insight Controller (If Equipped); Install Light Wiring (Optional) - Headsight CORN VENCE TUDO Instruction Manual

Install Horizon or Insight Controller (if equipped)

1. Connect the Horizon or Insight box to the main
Headsight harness.
2. Hold the box at rear of header as shown and
make sure Headsight harness can reach feeder
house electrical connection of combine.
•
Mark mounting hole locations
3. Drill mounting holes using ½" drill bit.
4. Secure box to header using hardware provided.

Install Light Wiring (Optional)

This step is only necessary for headers without lights pre-wired to OEM header connector.
1. Connect Headsight black wire (Ground)
to grounds of all lights.
2. Connect Headsight Yellow (Left Hazard)
to left warning lamp wire.
3. Connect Headsight Green (Right Hazard)
to right warning lamp wire.
4. Connect Headsight Brown (Stubble) to
stubble light lamp wire (if equipped).
See the Headsight combine manual for more details about how to install the
remaining wiring harness or control box and then connect each individual sensor.
06