Page 3
This icon designates an important instruction. Suggestions If you have any suggestions to improve this manual please call 574-546-5022 or email info@headsight.com. Disclaimers HEADSIGHT, HORIZON, PINPOINT, FORESIGHT, FEATHERSIGHT, TRUESENSE, TERRAHAWK, INSIGHT, the Headsight logo, the Horizon logo, and Terrahawk logo are trademarks of Headsight, Inc.
Installation Before working on combine or under header always: 1. Perform all combine and header manufacturer safety precautions for servicing header. 2. Insert stop to prevent movement of header. 3. Turn off combine and remove key from ignition. 4. Set combine parking brake. 5.
Mounting Sensors AGCO Poly (Outer Rows) 1. Remove steel skid plate at the front of the outer row. • Retain hardware for use later 2. Attach sensor to bracket using provided hardware B2237. 3. Slide U-shaped bracket into the snout once the sensor is attached.
4. Secure bracket to the snout reusing the hardware removed earlier. AGCO Poly (Inner Rows) 1. Remove the lower surface of the snout to allow sensor installation. • Drill holes then cut between them to prevent sharp corners or edges •...
4. Insert bracket into snout and attach with the provided 5/16” x 1” Torx screws. Steel Snouts 1. Locate pocket-shaped brackets and hardware labeled “B2240”. 2. Hold bracket as far forward as possible on the snout. • Remove skid plate if necessary •...
Sensor Wiring Properly routing the wiring is the most critical part of the installation process. Please take time to ensure that you have allowed sufficient slack for motion as well as sufficient clearance from moving header parts or crop flow. Harness Length Table 1.
Routing Wiring 1. Lay out wiring to appropriate snout. • Wiring will run from the sensor to the rear of the header near the combine’s feederhouse connection • See the Harness Length Table for assistance 2. Connect the wiring to the sensor. •...
3. Drill mounting holes using ½” drill bit. 4. Secure box to header using hardware provided. See the Headsight combine manual for more details about how to install the remaining wiring harness or control box and then connect each individual sensor.
Sensor Adjustment Insert header stop to prevent movement. Changing Swing 1. Loosen the bolt A holding downstop. 2. Slide the downstop to new position in slotted hole. • Raising downstop will increase voltage swing and allow higher maximum cutting height •...
Sensor Extensions Headsight recommends using the lowest setting that allows you to run as high as you desire. Increasing the length of the extension will reduce header control sensitivity. 1. Remove flange lock nut then remove arm and spring. 2. Install extension to sensor assembly with previously removed spring and flange locknut.
THIRD ANGLE SHEET PROJECTION HEADSIGHT INC. THE INFORMATION CONTAINED ON THIS DRAWING IS PROPRIETARY TO TOLERANCE HEADSIGHT, INC. ANY UNAUTHORIZED USE OF SUCH CONTENTS IS STRICTLY PROHIBITED. = ± .030 BRACKET - AGCO OUTER x.xx = ± .010 x.xxx = ± .005...
• Headsight, Inc. reserves the right to either inspect the product at the original retail purchaser’s location or require it to be returned to Headsight, Inc. for inspection.
Need help?
Do you have a question about the Corn AGCO 3000 and is the answer not in the manual?
Questions and answers