Sg (Sp/System Setting) - NEC 5020M-16 Operation Manual

Base Module

2.4.6.12. SG (SP/System Setting)

m
X
* Always valid without regard to the current system status.
Function:
This command is used to make various system settings and configure the iSP operation
environment.
Main Menu
System
configuration
settings
iSP settings
(*2)
display all
settings
(*1) Changes to configuration parameters are only allowed in the Maintenance mode.
(*2) In a duplicated iSP environment, iSP configuration must be done on each of the duplicated
iSPs.
Setting partition boot method and hot-plug permission:
Category
AC Link
Wake on
LAN
855-900549
B u
X X
Sub Menu
System common settings
(maintenance only) (*1)
Partition settings
(maintenance only) (*1)
Partition boot methods
and Hot-Plug permission
display all settings
LAN/Serial settings
FTP server settings
SNMP settings
display all setting
N/A
[AC LINK MODE]
Specifies whether or not the partition is to be
booted immediately when an AC power is
applied.
[Wake on LAN]
Specifies whether partition boot by Wake on LAN
is enabled or not.
Config. Parameter
System common
Partition configuration
Setting for the means
of partition boot and
hot plug enable
Show all system
settings on console.
LAN/serial port
configuration
FTP server settings
SNMP-related
configuration
Show all iSP settings
on the console.
Show all system and
iSP settings on the
console.
Configuration Parameter
2-76
Remarks
Valid after a next
partition boot
Valid after a next
partition boot
After a
configuration
change, iSP need
be reset.
After a
configuration
change, iSP need
be reset.
Default Setting
off
off