Sp Command Console - NEC 5020M-16 Operation Manual

2.4.5.

SP Command Console

If SP Command is chosen from the iSP Main Menu, SP Command Console appears on the
console screen.
To return from SP Command Console to the Main Menu, enter "^B" (press the B key while
holding down CTRL).
Some SP commands are only valid on the master iSP.
(Screen Example)
iSP MAIN MENU
0) OS(BIOS) serial console of partition#0 (INITIALIZING )
1) OS(BIOS) serial console of partition#1 (RUNNING
2) OS(BIOS) serial console of partition#2 (STOPPED
3) OS(BIOS) serial console of partition#3 (FAULT
4) OS(BIOS) serial console of partition#4 (POWER OFF
5) OS(BIOS) serial console of partition#5 (RUNNING
6) OS(BIOS) serial console of partition#6 (NOT CONFIGURED)
7) OS(BIOS) serial console of partition#7 (NOT CONFIGURED)
V) Virtual System Operator Panel
S) iSP commands
E) Exit
DISCONNECTALL) disconnect all console connections
<ENTER>
iSPyz> S
:
:
:
:
:
<CTRL>+<B>
(Description)
Description
No.
(a)
(b)
(c)
SP Command Console appears if S is entered at this prompt.
You can enter SP commands and monitor SP messages until ^B is entered.
CTRL+B quits SP Command Console. The screen returns to the Main Menu.
Description
2-27
Base Module
Description
No.
)
)
)
)
)
(a)
(b)
(c)
855-900549