Sp Command Console Buffer; Sp Command Prompt; 2.4.5.3. Sp Message Header - NEC 5020M-16 Operation Manual

Base Module
2.4.5.1.

SP Command Console Buffer

The output from SP Command Console may contain some critical information such as causes of
system status changes. Also when the iSP is running in LAN Console mode, it is not possible to
monitor the console output until LAN Console connection is established after the iSP boots up.
For these reasons, the iSP is provided with a buffering capability that buffers a certain amount
of messages that are output before SP Command Console connection is established.
The buffer has a size of approx. 1000 lines, capable to save the latest 1000 lines of output
messages.
The buffer contents can be listed with the "ML command."
2.4.5.2.

SP Command Prompt

When in SP Command mode, pressing the [ESC] key shows either of the following command
prompts.
iSPyz:--->

2.4.5.3. SP Message Header

SP messages are, in general, output with the following headers attached to them.
No message headers are attached to interactive prompts or messages used in SP commands,
however.
[iSPyz:INFO.ccccc] string
[iSPyz:WARN.ccccc] string
[iSPyz:ERRORccccc] string
855-900549
Prompt
Message Header
Information message:
ccccc represents a message ID.
string represents the message body.
Warning message
Error message
2-28
Description