Canon imageRUNNER ADVANCE C2000 Series Technical Workbook page 7

<Blank Display> .................................................................................................................................................. 114
When the main power is turned ON, the control panel locks up after the Progress Bar goes one third. . 114
Machine not recovering from Sleep Mode upon installation due to foreign substances adhering to DIMM's
contact ............................................................................................................................................................... 116
Mottling on the LCD control panel upon main power SW ON after installation ........................................ 117
Streaks on the LCD control panel upon turning the main power SW on after installation due to the Control
Panel Cable being inserted askew .................................................................................................................. 117
No display appears on Control Panel LCD due to poorly connected interface cable at power-on .............. 118
Only the main power supply lamp on the operation panel lighting up and no display on the LCD due to the
failure in the low voltage power supply assembly ......................................................................................... 119
Machines having system software earlier than Ver.30.06, when turning the Power ON, the machine does
not start but only the tally lamp is lit. ............................................................................................................ 119
<Duplex Jamming> ......................................................................................................................................... 120
010A Jam Code upon paper being attracted to the ITB due to the influence of the Secondary Transfer
Voltage in duplex mode ................................................................................................................................... 120
010A Jam occurs in the 2nd side of thin paper due to the paper separation error .................................... 121
<Other FAQs> .................................................................................................................................................. 121
Skew of 2nd side of 2-sided page/ abnormal noise caused by deformation of the right door assembly .... 121
Failure in printing operability when A4R/LTRR size paper is output from the multi-purpose tray ....... 124
E002-0006 due to the looseness of the connector for the harness ............................................................... 125
E002-0006 due to power shortage upon temperature increase of the fixing assembly resulted from false
detection by the main thermistor (TH1) ........................................................................................................ 126
Appendix...................................................................................................................................................... 127