Audio Menu; Settings Menu - WisyCom MTP60 User Manual

PRESET menu
MTP60 can recall configuration presets.
o
"Factory" recalls the Wisycom factory configuration.
o
"USER" (U01, U02...) recalls the configuration saved by menu
o
"PRESET" recalls preset saved with the Wisycom Manager or pre-configured by Wisycom
TUNING > Frequency menu
In this menu current channel/group and frequencies can be setup.
The name of the group is shown on the top right of the display.
Sync group is a quick self-settable channel synchronized by receiver (with SYNC group, on the top
right of the display is shown the name of the synchronized receiver).
Use arrows to change value and <ENTER> to confirm.
Using quick channel setup buttons (<CH>), it is possible to enter quickly in the tuning menu.
TUNING > Level menu
RF power can be setup to 20mW, 20mW Linear, 50mW or 100mW (depending on the Power profile,
see TUNING>Pwr Profile menu).
TUNING > Pwr on
Set to ON to activate the transmission. LED2 becomes fixed green when the transmitter is tuned and
RF power is ON.

AUDIO menu

With this menu it is possible to set all the audio parameters: gain, modulation (Narrowband or
Wideband), type of microphone, audio filters and the Tone.

SETTINGS menu

Use this menu to
o
activate the Bluetooth interface
o
activate the Irda interface
o
set type of battery used
o
configure LEDs behaviour
o
configure brightness and time of display
INFO menu
Use this menu to check information about the transmitter (serial number, frequency range,
firmware and hardware version) and its status (voltage, temperature and alarms).
MTP60 User Manual
5