Table of Contents
Advertisement
Figure 4-3 Removing the Access Panel
To install the access panel:
1.
Align the standoffs of the access panel with the J-slots on the chassis. Lower
the access panel down onto the chassis.
2.
Push the access panel toward the front of the server until it closes.
3.
Tighten the two captive screws on the rear of the server securing the access
panel to the server clockwise.
4.4.2
Super-Capacitor Replacement
To remove the super-capacitor:
1.
Remove the access panel.
2.
Disconnect the cable of the super-capacitor.
3.
Undo the velcro of the super-capacitor.
4.
Remove and put the super-capacitor into an antistatic bag.
Figure 4-4 Removing the Super-Capacitor
23
Advertisement
Table of Contents
