Table of Contents
Advertisement
Figure 32. Moving a Chassis onto a Rack or Cabinet - SAN768C-6 Chassis
1. Push the sides of the lower half of the front side of the chassis (do not push on any of the
modules or module handles).
2. Chassis mounting brackets.
3. Rack vertical mounting rails.
4. Bottom support rails
Tip : To adjust the placement of the chassis on the bottom-support rails, you can use the handles on
the sides of the chassis.
5. If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level
of the rails or no more than 1/4 inch (0.6 cm) below the rails.
This action helps to prevent the bottom of the chassis from getting caught on the bottom expansion
edges of the bottom-support rails.
6. Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come
in contact with the vertical mounting rails on the rack.
Chapter 3. Installing the IBM c-type SAN Device 71
Advertisement
Table of Contents
