Table of Contents
Advertisement
9. Remove the USB drive from the Supervisor-1 Module (this drive has copies of the Supervisor-1
Module configuration, license, and software images) and insert it in the USB port on the active
Supervisor-4 Module (ACTIVE LED is green).
10. Connect a console to the active supervisor module as explained in Connecting a Console to the
Switch.
11. If you are setting up the initial configuration for the supervisor module, the initial setup script will ask
you if you want to enforce the secure password standard. Make your selection, enter your password,
and then confirm the password by entering it again.
---- System Admin Account Setup ----
Do you want to enforce secure password standard (yes/no) [y]:
Enter the password for "admin":
Enter the password for "admin":
12. When you are asked to enter the basic configuration, enter no.
---- Basic System Configuration Dialog VDC: 1 ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system. Please register Cisco Nexus7000 Family devices promptly
with your supplier. Failure to register may affect response times
for initial service calls. Nexus7000 devices must be registered to
receive entitled support services. Press Enter at anytime to skip a
dialog. Use ctrl-c at anytime to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): no
13. When asked to log in, enter the login and password that you specified in step "11" on page 111.
User Access Verification
switch login:
Password:
14. Verify that the switch is running the required version of the NX-OS software by using the show
version command.
switch(config)# show version
Note : If the version of the NX-OS is not the same as you intended to use, perform an upgrade to the
appropriate version (NX-OS Release 8.4(1) or later). To upgrade an image version on the switch, refer
the 9000 NX-OS Software Upgrade and Downgrade Guide, Release 8.x guide.
15. Reinstall the license files on the new Supervisor-4 Module.
switch(config)#
copy usb1:licenses_archive_file_name.tar bootflash:switch_license.tar
Copy progress 100% 10KB
Copy complete, now saving to disk (please wait)...
switch(config)# copy bootflash:switch_license.tar bootflash:switch_license.lic
Copy progress 100% 10KB
Copy complete, now saving to disk (please wait)...
switch(config)# install license bootflash:switch_license.lic
Installing license ...........................done
switch# show license usage
Feature
--------------------------------------------------------------------------
IOA_X9334
FM_SERVER_PKG
MAINFRAME_PKG
ENTERPRISE_PKG
SAN_ANALYTICS_PKG
SAN_TELEMETRY_PKG
--------------------------------------------
Ins
Lic
Status
Count
No
0
In use
No
-
Unused
No
-
Unused
Yes
-
Unused
No
-
In use
No
-
Unused
Chapter 3. Installing the IBM c-type SAN Device 111
Expiry Date
Comments
Grace 115D 2H
never
Grace 119D 20H
Grace 109D 1H
-
-
-
Advertisement
Table of Contents
