Raising The Roll Bar; Starting And Shutting Off The Engine - Toro LT2240 Operator's Manual

1. Roll-bar pin (lower position)
6. Secure roll-bar pins to the pivot brackets with
the hairpins.

Raising the Roll Bar

1. Remove the hairpins that secure the roll-bar pins
to the pivot brackets of the lower roll-bar frame.
2. Remove the roll-bar pins from the pivot brackets
(Figure 31).
1. Roll-bar pin
3. Raise the upper roll bar until the holes in the roll
bar align with the pivot brackets
Figure 30
Figure 31
(Figure
g348269
1. Roll-bar pin
2. Pivot bracket upper hole
(lower roll-bar frame)
4. Insert the roll-bar pins through the upper holes
of the pivot brackets and the upper roll bar
(Figure
5. Secure roll-bar pins to the pivot brackets with
the hairpins
Starting and Shutting Off
the Engine
Important:
g348269
first time, the engine has shut off due to lack of
fuel, or you have performed maintenance on the
fuel system—you must bleed the fuel system
before starting the engine; refer to
Fuel System (page
32).
WARNING
Operating the machine in an unsafe manner
could result in personal injury.
Before starting the engine, ensure that the
following conditions are met:
• The area is clear of bystanders.
• The cutting unit drive is disengaged.
• The parking brake is engaged.
• The traction pedals are in the neutral
position.
Important:
engine start lockout; refer to
Operator-Presence Controls (page
22
Figure 32
3. Hairpin
4. Upper roll bar
32).
(Figure 32).
If you are starting the engine for the
43).
This machine is fitted with an
Understanding the
g348268
Bleeding the
19).