Toro LT2240 Operator's Manual page 29

1. Hex plug
7. Assemble a bolt (12 x 40 mm) and washer (12
mm) into the hole at the center of the motor end
plate (Figure 45).
1. Front wheel motor
2. Hex plug
8. Tighten the bolt in the threaded hole in
the brake piston until the brake releases
(Figure 45).
9. Repeat steps 6 through
left side of the machine.
Bypassing the Transmission
Pump
1. Decommission the hydraulic service braking
system by turning the bypass valve (located
under the transmission pump) counterclockwise
(Figure 46), a maximum of 3 turns.
The mower is now in a freewheel condition and
can be towed for a short distance at slow speed.
Figure 44
Figure 45
3. Washer (12 mm)
4. Bolt (12 x 40 mm)
8 for the brake at the
Important:
machine while it is towed. When the engine
is shut off, there is no hydraulic steering
assist—steering the machine feels heavy.
g292377
1. Transmission bypass valves
2. Lower and latch the platform; refer to
the Platform (page
3. Remove the wheel chocks.
g014451
Towing the Machine
Important:
Do not tow the machine faster than
3 to 5 km/h (2 to 3 mph) and for no longer than
3 minutes; otherwise, internal damage to the
transmission may occur.
•
Use the front tow ring to tow the machine.
•
Tow the machine a short distance, at slow speed,
for no longer than 3 minutes.
29
You must manually steer the
Figure 46
35).
g014450
Lowering