Toro LT2240 Operator's Manual page 13

Transmission Neutral Indicator Light
The transmission neutral indicator light illuminates
when the traction pedals are in the N
and the ignition key is turned to the R
(Figure 17).
Note:
You must engage the parking brake for the
transmission neutral indicator light to illuminate.
Figure 17
1. Transmission neutral indicator light
Engine Preheat Indicator Light
Turn the ignition key to position P
engine preheat indicator light illuminates and the
glow plugs energize to help start a cold engine.
(Figure 18).
Important:
Attempting to start a cold engine
before using the preheat may cause unnecessary
battery wear.
Figure 18
1. Engine pre-heat indicator light
position
EUTRAL
position
UN
g348167
. The
REHEAT
g348166
13
Traction Pedals
Forward travel: Press the forward traction pedal
to drive the machine forward and increase ground
speed. Release the pedal to reduce ground speed
(Figure 19).
Reverse travel: Press the reverse traction pedal to
drive the machine backward and increase ground
speed. Release the pedal to reduce ground speed
(Figure 19).
Stop (Neutral): To stop the machine, use 1 of the
following procedures:
•
Reduce your foot pressure on the traction pedal
and allow it to return to the neutral position. The
machine dynamically brakes to a smooth stop.
•
Tap or hold the opposite pedal briefly—this stops
the machine faster than dynamic braking.
Figure 19
1. Reverse traction pedal
Adjustable Steering Column
Adjust the steering wheel and column only when the
machine is parked on level ground.
1. To tilt the steering wheel, press the foot pedal
down.
2. Position the steering tower to the most
comfortable position and release the pedal
(Figure 20).
g014420
2. Forward traction pedal