Removing The Storage Compartment; Installing The Storage Compartment; Locating The Lift Points - Toro LT2240 Operator's Manual

3. Fully lower the platform and move the
platform-latch handle toward the rear of the
machine until the latch hooks fully engage the
locking bar (Figure
Figure 55
1. Platform-latch handle
Removing the Storage
Compartment
1. At the left side of the operator's platform, open
the door of the storage compartment
Figure 56
1. Washer
2. Knob
2. Remove the 3 knobs and 3 washers that secure
the storage compartment to the machine, and
remove the compartment
55).
(Figure
3. Storage compartment
(Figure 56).
Installing the Storage
Compartment
1. Align the holes on the bottom of the storage
compartment with the holes in the chassis
brackets.
2. Assemble the storage compartment to the
machine with the 3 knobs and 3 washers
57)
g290370
56).
1. Washer
2. Knob
3. Close the storage-compartment door.

Locating the Lift Points

Note:
Use jack stands to support the machine when
you lift it.
WARNING
Mechanical or hydraulic jacks may fail to
g348234
support the machine and cause serious injury.
Use jack stands when supporting the
machine.
•
Front—under the front arm mount
•
Rear—axle tube on the rear axle
36
Figure 57
3. Storage compartment
(Figure
g348233