Table of Contents
Advertisement
Figure 79
1. Positive (+) cable on
discharged battery
2. Positive (+) cable on
booster battery
3. Negative (–) cable on the
booster battery
4. Negative (–) cable on the
engine block
4.
Connect the other end of the positive cable to
the positive terminal of the booster battery.
5.
Connect the black negative (–) cable to the other
terminal (negative) of the booster battery.
6.
Make the final connection on the engine block of
the stalled machine (not to the negative battery
post), away from the battery, and stand back
(Figure
80).
Figure 80
1. Engine block
7.
Start the machine and remove the cables in
the reverse order of connection (disconnect the
negative cable from the engine block first).
g012785
5. Booster battery
6. Discharged battery
7. Engine block
g024213
g013117
2. Negative (–) cable
Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Roll-Bar
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
•
Check that both the mounting hardware and the
knobs are in good working condition.
•
Make sure that the knobs are fully engaged with
the roll bar in the raised position.
Note:
The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to fully
engage both knobs
60
(Figure 81
and
Figure
82).
Advertisement
Table of Contents
