Servicing The Battery; Raising The Roll Bar - Toro 77281TA Setup Instructions

5

Servicing the Battery

No Parts Required
Procedure
Important:
Do not run the machine with the
battery disconnected; electrical damage may
occur to the engine.
1. Charge the battery. Refer to the Operator's
Manual for instructions.
2. Connect the negative battery cable.
Note:
If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black)
cable to the negative battery terminal. Slip the
insulator boot over the positive terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount
1. Ensure that the ground
cable does not rub against
the lower shock mount.
2. Ensure that the ground
cable does not rub against
the trailing arm.
(Figure 1).
Figure 1
3. Ground cable
6

Raising the Roll Bar

No Parts Required
Procedure
Important:
Always use the seat belt with the roll
bar in the raised position.
1. Remove the hairpin cotters and remove the 2
pins.
2. Raise the roll bar to the upright position.
3. Install the 2 pins, and secure them with the
hairpin cotters.
g236732
3
Figure 2
g399201