Prominence Home 40278 Owner's Manual page 8

Fitter Plate
Screw
Single-pin
Connector
Light Kit
Glass Shade
Fitter Plate
Switch Housing Cap
ASSEMBLY INSTRUCTIONS
Fitter Plate
13
Light Kit
14
Socket Ring
15
Bulb
16
Fitter Plate
Screw
13. Note: If you wish to install the fan without the light kit,
proceed to Step16.
To install the light kit, remove the three fitter plate
screws from the fitter plate. Then connect the single-pin
connector from the fitter plate to the single-pin connector
in the light kit--blue to black and white to white. Secure
the light kit to the fitter plate using the previously
removed fitter plate screws.
14. Remove the three socket rings from each of the
sockets on the light kit. Lift glass shades onto the light kit
and secure with previously removed socket rings.
14. Install the E26-base B10 LED bulbs into the sockets of
the light kit.
16. To install without the light kit, remove the three fitter
plate screws from the fitter plate. Then attach the switch
housing cap to the fitter plate using the fitter plate screws.
8