Prominence Home Arthur 52" Owner's Manual

Prominence Home Arthur 52" Owner's Manual

Indoor ceiling fan

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Prominence Home Arthur 52"

  • Page 2: Package Contents

    PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Motor Housing 10. Blade (x5) 2. Upper Mounting Bracket 11. Blade Arm (x5) 3. Lower Mounting Bracket 12. Hardware Kit 4. Motor 13.
  • Page 3 EXPLODED VIEW DETAIL Motor Housing Mounting Housing Upper Mounting Bracket Screw Mounting Bracket Screw Lower Mounting Bracket Motor Blade Fitter Plate Blade Arm Light Kit Glass Shade Bulb DIMENSION REFERENCE A. 14.28 in. B. 6.51 in. C. 11.07 in.
  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan.
  • Page 5 SAFETY INSTRUCTIONS WARNING: To avoid risk of electric shock, be sure to shut off power at the main fuse or circuit breaker box before installing or servicing this fixture. Turning off the electrical power by using the light switch is not sufficient to prevent electrical shock.
  • Page 6 ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. 2. Install the upper mounting bracket to the outlet box (not included) using the screws and washers provided with the outlet box.
  • Page 7 ASSEMBLY INSTRUCTIONS 5. Reinstall the previously removed mounting bracket Upper Mounting Bracket screws to secure the lower mounting bracket to upper mounting bracket. Securely tighten the screws. Lower Mounting Bracket Mounting Bracket Screw SECONDARY HANGING SYSTEM For installation in the United States: Building codes Braided Cable in the U.S.A.
  • Page 8 ASSEMBLY INSTRUCTIONS 9. Use wire connectors to connect the fan wires to the power supply wires according to the wiring diagram Black (Hot) and the following instructions: White (Neutral) • Connect the green wire from the lower bracket to the Bare/Green (Ground) bare/green (ground) supply wire.
  • Page 9 ASSEMBLY INSTRUCTIONS 13. Install the blade arm to the underside of the motor assembly with previously removed motor screws (Step 3, Slot page 6). Tighten each blade arm completely before moving to the next. Repeat for each blade arm. Blade Arm Note: The notch in the fitter plate allows a Phillips screwdriver (not included) access to motor screws.
  • Page 10 ASSEMBLY INSTRUCTIONS 17. Attach pull chain extensions to the pull chains. Note: The pull chain in the center of the light kit controls the light. Pull Chain Extension 18. Restore the power at the main fuse or circuit breaker and wall switch. Assembly is complete.
  • Page 11 OPERATING INSTRUCTIONS 1. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in winter without feeling a difference in your Reverse comfort. Switch In warmer weather, push the reverse switch left which will result in downward airflow creating a wind chill effect.
  • Page 12: Troubleshooting

    TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-706-3267, 8 a.m.
  • Page 13: Limited Lifetime Warranty

    LIMITED LIFETIME WARRANTY To obtain Service, please contact the Service Department: 1-877-706-3267, 8 a.m. - 5 p.m. Central, Monday - Friday. Model Name: 52” Ceiling Fan Model No: 51486 - Espresso Set forth below, the manufacturer, Hong Kong China Electric appliance Company (HKC) warrants the fan motor for this ceiling fan to be free from defects in workmanship and material for the life of the product.

This manual is also suitable for:

51486

Table of Contents