Prominence Home 40278 Owner's Manual page 7

Black (hot)
White (neutral)
Bare/Green
(ground)
Canopy
Blade Screw
Blade Washer
Blade Arm
Motor Screw
ASSEMBLY INSTRUCTIONS
Wire
Connector
9
WARNING: Do NOT
wire the fan motor to a
variable-speed (dimmer)
wall control.
Mounting
Bracket Screw
Round
Hole
10
J-shaped Slot
11
Blade
Notch
12
Blade Arm
9. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note: Closemount installation does not use the downrod,
so there will only be two green wires to connect.
Note: If there is a second hot/power wire coming from the
outlet box, connect it to the Blue (light power) fan wire for
separate light and fan control.
Important: After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
10. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy in a clockwise direction until the
mounting bracket screws are completely engaged in
the J-shaped slots. Install the two previously removed
mounting bracket screws in the round holes. Securely
tighten all four mounting bracket screws.
11. Partially insert the blade screws along with the blade
washers through the blade and into the blade arm.
Tighten each blade screw with a Phillips screwdriver (not
included), starting with the one in the middle. Repeat this
step for the remaining blades and blade arms.
12. Install the blade arm to the underside of the motor
assembly with the motor screws previously removed in
Step 3. Tighten with Phillips screwdriver. Repeat for each
blade arm. Note: The notch in the fitter plate provides a
Phillips screwdriver access to the motor screw holes.
7