Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Prominence Home 50650
Summary of Contents for Prominence Home 50650
-
Page 2: Package Contents
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Canopy 12. Switch Housing 2. Canopy Cover 13. Switch Housing Screw (x3) 3. Mounting Bracket Screw 14. Switch Housing Cap (x4) 15. Light Kit 4. -
Page 3: Mounting Options
DIMENSION REFERENCE A. 18.82 in. B. 13.2 in. C. 13.2 in. D. 5.13 in. MOUNTING OPTIONS Three Mounting Options Closemount Downrod Mount Angled Ceiling Mount (Up to 16 degrees) Choose one of the following mounting options: Closemount Installation is best suited for ceilings lower than 8 feet. It does not utilize the downrod. Downrod Mount is best suited for ceilings 8 ft. -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. - Page 5 ASSEMBLY INSTRUCTIONS 1.Turn OFF the electrical power at the main fuse or circuit breaker. DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. Mounting 2. Remove the mounting bracket by removing the two Bracket Screw mounting bracket screws from the round holes in the canopy.
- Page 6 ASSEMBLY INSTRUCTIONS 5. DOWNROD MOUNT - Remove the downrod clip and downrod pin from the downrod. Then, loosen but do not Downrod remove the two set screws at the top of the yoke. Downrod Clip Downrod Set Screw Yoke Braided 6.
- Page 7 ASSEMBLY INSTRUCTIONS SECONDARY HANGING SYSTEM Braided Cable For installation in the United States: Building codes Brace in the U.S.A. do not require installation of a Secondary Hanging System. If desired, the braided cable can be cut and removed using wire cutters (sold separately). Skip to Step 12.
- Page 8 ASSEMBLY INSTRUCTIONS WARNING: Do NOT 12. Use wire connectors to connect the fan wires to the wire the fan motor Black (Hot) power supply wires according to the wiring diagram and to a wall control. White (Neutral) the following instructions: Bare/Green (Ground) •...
- Page 9 ASSEMBLY INSTRUCTIONS Cage Screw 16. Remove the four cage screws from the brackets inside the shade. Install the E26-base LED bulb in the socket. Light Cage Then attach the light cage to the shade using the four cage screws. Repeat for each shade. Bulb Bracket Shade...
- Page 10 OPERATING INSTRUCTIONS 1. Use the reverse switch, located on the switch housing to optimize your fan for seasonal performance. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in Reverse Switch winter without feeling a difference in your comfort.
-
Page 11: Troubleshooting
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-706-3267, 9 a.m.-5 p.m. -
Page 12: Limited Lifetime Warranty
1-877-706-3267, 9 a.m.-5 p.m. Central time. Model Name: 52” Ceiling Fan Model No: 50650 - Bronze The manufacturer warrants this fan to be free from defects in workmanship and materials present at time of shipment from the factory for a lifetime from the date of purchase by the original purchaser. The retailer...