Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Prominence Home Lanissa 52
Summary of Contents for Prominence Home Lanissa 52
-
Page 2: Package Contents
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Canopy 13. Light Kit 2. Canopy Cover 14. Glass Shade 3. Mounting Bracket 15. Lens 16. Finial Cap 4. Mounting Bracket Screw (x4) 17. -
Page 3: Mounting Options
DIMENSION REFERENCE A. XXX in. B. XXX in. C. 8.24 in. D. 5.13 in. MOUNTING OPTIONS Two Mounting Options Downrod Mount Angled Ceiling Mount (Up to 16 degrees) Choose one of the following mounting options: Downrod Mount is best suited for ceilings 8 ft. or higher. For taller ceilings you may want to use a longer downrod (not included). -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. - Page 5 SAFETY INSTRUCTIONS WARNING: To avoid risk of electric shock, be sure to shut off power at the main fuse or circuit breaker box before installing or servicing this fixture. Turning off the electrical power by using the light switch is not sufficient to prevent electrical shock.
- Page 6 ASSEMBLY INSTRUCTIONS 1.Turn OFF the electrical power at the main fuse or circuit breaker. DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. Mounting 2. Loosen all four mounting bracket screws and Bracket Screw completely remove the two screws from the round holes in the canopy.
- Page 7 ASSEMBLY INSTRUCTIONS 6. Insert the downrod into the yoke and reinstall the downrod pin and downrod clip. Then retighten the two set screws. Set Screw Note: With wiring extending out of the downrod, measure Downrod 8 inches of lead wire and cut the excess wire with wire Downrod Pin cutters (not included).
- Page 8 ASSEMBLY INSTRUCTIONS Secondary Support Screw 9. Tighten the secondary support screw securing the braided cable. 10. Use wire connectors to connect the fan wires to the power supply wires according to the wiring diagram and the following instructions: • Connect the white wire from the fan to the white (neutral) supply wire.
- Page 9 ASSEMBLY INSTRUCTIONS Notch 13. Align the two motor in the blade arm with two motor screw holes in the underside of the motor assembly. Secure the blade arm to motor assembly using two motor screws. Completely secure each blade arm to the motor assembly before moving to next.
- Page 10 ASSEMBLY INSTRUCTIONS 17. Lift the lens over the threaded rod and secure with hex nut. Then, lift the finial cap over the threaded rod and secure with finial. Threaded Lens Hex Nut Finial Cap Finial Front Back 18. Remove the battery door from the back of the remote using a flat-head screwdriver (not included).
- Page 11 OPERATING INSTRUCTIONS 1. To operate the fan using the remote, press and release LED Indicator the following buttons: Fan Off Fan Off - Turns the power to fan off. Light On/Off Light On/Off - Tap the light control button to turn the light off and on.
- Page 12 OPERATING INSTRUCTIONS 3. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in winter without feeling a difference in your Reverse comfort. Switch In warmer weather, push the reverse switch to the left for downward airflow creating a wind chill effect.
-
Page 13: Troubleshooting
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-706-3267, 8 a.m. -
Page 14: Limited Lifetime Warranty
LIMITED LIFETIME WARRANTY To obtain Service, please contact the Service Department: 1-877-706-3267, 8 a.m. - 5 p.m. Central Time, Monday - Friday. Model Name: 52” Ceiling Fan Model No: 51676 - Brushed Nickel Set forth below, the manufacturer, Hong Kong China Electric appliance Company (HKC) warrants the fan motor for this ceiling fan to be free from defects in workmanship and material for the life of the product.