Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Prominence Home Enoki 51642
Summary of Contents for Prominence Home Enoki 51642
-
Page 2: Package Contents
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Canopy 12. Fitter Plate Screw (x3) 2. Canopy Cover 13. Light Pan 3. Mounting Bracket 14. Light Pan Screw (x3) 4. Canopy Screw (x2) 15. -
Page 3: Mounting Options
DIMENSION REFERENCE A. 16.72 in. B. 12.06 in. C. 7.9 in. D. 5.13 in. MOUNTING OPTIONS Two Mounting Options Downrod Mount Angled Ceiling Mount (Up to 10 degrees) Choose one of the following mounting options: Downrod Mount is best suited for ceilings 8 ft. or higher. For taller ceilings you may want to use a longer downrod (not included). -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. - Page 5 SAFETY INSTRUCTIONS WARNING: To avoid risk of electric shock, be sure to shut off power at the main fuse or circuit breaker box before installing or servicing this fixture. Turning off the electrical power by using the light switch is not sufficient to prevent electrical shock.
- Page 6 ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. Downrod Mount 2. Attach mounting bracket to outlet box (not included) using screws and washers provided with the outlet box.
- Page 7 ASSEMBLY INSTRUCTIONS 5. Insert the downrod into the yoke and reinstall the downrod pin and downrod clip. Then re-tighten the two set screws. Note: With wiring extending out of the downrod, measure 8 inches of lead wire and cut the excess wire Set Screw with wire cutters (not included).
- Page 8 ASSEMBLY INSTRUCTIONS Support Open Loop Washer 9. Install secondary support screw, secondary spring Secondary washer, and support washer partly into the side of the Spring Washer brace installed in the ceiling. Then lift the braided cable up and over the ceiling brace and place the open loop of the braided cable around the secondary support screw.
- Page 9 ASSEMBLY INSTRUCTIONS 12. Remove one of the canopy screws from the bottom of the mounting bracket. Lift the key slot in the canopy over the head of the canopy screw preassembled to the mounting bracket. Twist the canopy clockwise to lock. Replace the canopy screw in the round hole in the bottom Canopy of the canopy and tighten both screws.
- Page 10 ASSEMBLY INSTRUCTIONS 16. Loosen two and completely remove the third light pan screw from the light pan. Connect the 9-pin connector from the fan to the 9-pin connectors from the light kit. Lift the two keyholes in the light kit over the light pan screws Light Pan 9-pin and turn the light kit clockwise.
- Page 11 ASSEMBLY INSTRUCTIONS 19. If desired, the wall bracket can be installed to the wall Wall Bracket using the two mounting screws. Store the remote in the wall bracket when not in use. Mounting Screw 20. Turn on the electrical power at the main fuse or circuit breaker and the wall switch.
- Page 12 OPERATING INSTRUCTIONS LED Indicator 2. To operate the fan using the remote, press and release Fan Off the following buttons: Light On/Off Fan Off - Turns the power to fan off. Light On/Off - Turns the light on and off. Press and hold to High Speed dim or brighten lights (for dimmable bulbs only).
-
Page 13: Troubleshooting
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-706-3267, 8 a.m. -
Page 14: Limited Lifetime Warranty
LIMITED LIFETIME WARRANTY To obtain service, please contact the Service Department: 1-877-706-3267, 8 a.m. - 5 p.m. Central, Monday - Friday. Model Name: 52” Ceiling Fan Model No: 51642 - Matte Black 51643 - Pewter 51644 - White 51645 - Blue Set forth below, the manufacturer, Hong Kong China Electric appliance Company (HKC) warrants the fan motor for this ceiling fan to be free from defects in workmanship and material for the life of the product.