Prominence Home 40278 Owner's Manual page 6

Downrod
Downrod Pin
Motor Assembly
Yoke Cover
Downrod
Set Screw
Downrod Clip
Mounting
Bracket
Tab
Slot
Downrod
ASSEMBLY INSTRUCTIONS
Downrod Clip
5
Yoke
Set Screw
Canopy
6
Downrod
Yoke Cover
7
Downrod Pin
8
DOWNROD INSTALLATION:
5. Remove the downrod clip and downrod pin from the
downrod. Then partially loosen the two set screws in the
yoke at the top of the motor assembly.
6. Feed the wires coming from the yoke through the yoke
cover, canopy, and downrod.
7. Insert the downrod into the yoke and re-install the
downrod pin and downrod clip. Then re-tighten the two
set screws.
Note: With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire
with wire cutters (not included). Then strip 1/2" of
insulation from the end of each wire.
8. Lift the downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated in
the slot in the downrod ball.
WARNING: The fan and/or downrod should
not rotate in the mounting bracket if installed
correctly. Failure to align the slot in the downrod ball with
the tab on the mounting bracket may result in fan falling
causing serious injury or death.
6