Table of Contents
Advertisement
10) Remove all 18 screws holding the burner tray
assembly in place.
11) Carefully lift the burner tray assembly out.
12) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly, continue.
13) Remove two (2) thermopile wires.
14) Remove thermocouple with a 9 mm (metric)
wrench.
15) Remove pilot nut with an 11 mm wrench.
16) Remove valve to orifice nut with a 13/16" wrench.
17) Remove inlet pipe with pipe wrench. Note
orientation of 90
elbow.
o
18) Remove two (2) phillips head M5 screws on
each side of the valve.
19) Remove valve and remove gas out 90
fitting. Note orientation of fitting.
Hampton® H35U Direct Vent Freestanding Gas Stove
Installing Valve Assembly
1) To install a new valve assembly, reverse instruc-
tions for removing valve. See assembly steps
1-12.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 13-19.
o
brass
maintenance
45
Advertisement
Table of Contents
