Table of Contents
Advertisement
Step-by-Step Installation Instructions
Note: To review the pattern of blinking
lights, press and hold the RESET button
for 5 seconds.
8.
Turn OFF power.
9.
Write the contact information of the
installer on the label on the inside of the
Wall Connector.
Secure the Cover and Power Up
1.
Use a T20 security pin Torx driver to
install the remaining screws on the sealing
cover. Ensure that the cover is properly
aligned before fully tightening the screws.
2.
Attach the outer cover to the sealing
cover starting with the latch at the top.
Engage the snaps on the sides and align
the mounting tab with the housing at the
bottom.
3.
Use a T10 Torx driver to install the screw
that secures the bottom of the outer cover
to the housing.
4.
Close any unused openings with power
and signal conduit plugs.
Note: There should not be any visible
openings to the inside of the Wall
Connector, and the Wall Connector should
be completely sealed from the
environment.
5.
Turn ON the power. The installation is
correct if the LEDs go through a sequence
of flashing, ending with the top Green
LEDs staying solidly ON. If there is a solid
or flashing Red LED, resolve the error
before you continue (refer to
Troubleshooting on page 23).
22
Note: To review the pattern of blinking
lights, press and hold the Reset button for
5 seconds.
6.
Attempt to charge the vehicle to ensure
the Wall Connector is operating correctly
and charging at the selected operating
current. For instructions on how to charge,
refer to the owner information provided
with the vehicle.
Advertisement
Table of Contents
