EMC2 Data Domain DD2500 Installation And Setup Manual page 22

Installation and Setup Guide
Pending Network Settings
Hostname
Domain name
Default Gateway
DNS Server List
Port Enabled
----- -------
eth0a no
eth0b no
eth0c no
eth0d no
22 Installation and Setup Guide
5. Enter a fully qualified domain name (FQDN) for the hostname; for example,
str01.yourcompany.com
discover it.
Enter the hostname for this system (fully-qualified domain name)[]:
6. Enter the DNS domain name; for example,
name, if the system was able to discover it.
Domainname
Enter your DNS domainname []:
7. Enable and configure each Ethernet interface. Accept or decline DHCP for each
interface. If the port does not use DHCP to discover network parameters automatically,
enter the information manually.
Ethernet port eth0a
Enable Ethernet port eth0a (yes|no|?) [yes]: no
Ethernet port eth0b
Enable Ethernet port eth0b (yes|no|?) [no]: yes
Use DHCP on Ethernet port eth0b (yes|no|?) [no]:
Enter the IP address for eth0b
[192.168.10.185]:
Enter the netmask for eth0b
[255.255.255.0]:
8. Enter the IP address of the default routing gateway. Or accept the default gateway, if
the system was able to discover it.
Default Gateway
Enter the default gateway IP address
: 192.168.10.1
9. Enter the IPv6 address of the default routing gateway. Or accept the IPv6 address of
the default gateway, if the system was able to discover it. If IPv6 is not in use, leave
the field empty and press
IPV6 Default Gateway
Enter the ipv6 default gateway IP address
:
10.Enter up to three DNS servers to use for resolving hostnames to IP addresses. Use a
comma-separated or space-separated list. Enter a space for no DNS servers. Or accept
the IP addresses of the DNS servers, if the system was able to discover them.
DNS Servers
Enter the DNS Server list (zero, one, two or three IP addresses)
: 192.168.10.1
11.A summary of the network settings displays. You can accept the settings (
the settings and exit to the command line (
current section and change the settings (
previous response for each prompt. Press
enter a new one.
ddbeta1.dallasrdc.com
dallasrdc.com
192.168.10.1
192.168.10.1
Cable DHCP
----- ----
no n/a
no n/a
no n/a
no n/a
. Or accept the hostname, if the system was able to
yourcompany.com
to continue.
Enter
Cancel
). Entering
Retry
to accept the displayed value or
Return
IP Address
--------------
n/a
n/a
n/a
n/a
. Or accept the domain
Save
), or return to the beginning of the
displays your
Retry
Netmask or Prefix Length
------------------------
n/a
n/a
n/a
n/a
), reject