Enable Administrative Communication; End User License Agreement (Eula) - EMC2 Data Domain DD2500 Installation And Setup Manual

Installation and Setup Guide

Enable administrative communication

End User License Agreement (EULA)

20 Installation and Setup Guide
If the battery is good, but the system will not boot, or if the battery is failing to
l
charge, contact EMC Data Domain Technical Support.
Note
See the DD2500 back panel on page 7
1. Connect an administrative console to the serial port on the back panel of the system.
2. Launch a terminal emulation program from your computer and configure the following
communication settings:
Setting
Baud rate
Data bits
Stop bits
Parity
Flow control
Emulation
3. Log into the CLI as the
localhost.localdomain login: sysadmin
Password: <system_serial_number>
4. Enter the default password, which is the system serial number (SSN). The SSN is on
the SSN pull-out tag at the top, left side of the back panel of the system, shown
below. See also Onboard interfaces and LEDs on page 9
Figure 23 SSN pull-out tag
The first time you log in to the system, the End User License Agreement (EULA) displays.
At the end of the EULA, you are prompted for acceptance:
for the locations of the onboard interfaces.
user.
sysadmin
Value
9600
8
1
None
None
VT-100
for the location.