Run The Configuration Wizard - EMC2 Data Domain DD2500 Installation And Setup Manual

Run the configuration wizard

Configuring the network
Press any key then hit enter to acknowledge the receipt of EULA
information:
Customer acceptance is required.
Note
An EMC representative should
accept the EULA, press
Ctrl-C
installation. Later, the customer can enter the
redisplay the EULA and accept it.
The CLI configuration wizard starts automatically the first time the system boots. The
wizard prompts you through a series of questions that provide just enough information
for initial system configuration and basic network connectivity.
Note
You can initiate the CLI configuration wizard manually by entering the
command.
Procedure
1. Enter to begin configuring the system.
yes
Do you want to configure system using GUI wizard (yes|no) [no]
: yes
Answering initiates a shortened version of the CLI configuration wizard that
yes
provides enough information to configure the system for network access. Afterward,
you can use the GUI (Data Domain System Manager) for additional configuration.
Answering initiates a longer, more robust, version of the CLI configuration wizard.
no
2. Enter and change the password.
yes
Note
If you are an EMC internal resource or partner, do not change the password unless
specifically directed to do so by the customer.
Change the 'sysadmin' password at this time? (yes|no):
3. Enter to configure the system for network connectivity.
yes
Network Configuration
Configure Network at this time (yes|no)
[no]: yes
4. Enter to configure DHCP to obtain network parameters (such as, the hostname,
yes
domain name, and IP addresses) dynamically from a DHCP server. Or enter
configure the parameters manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway and
DNS servers? (At least one interface needs to be configured
using DHCP) (yes|no|?)
EMC Data Domain DD2500 System Installation and Setup Guide
not accept the agreement. If a customer is not present to
to exit from the EULA acceptance screen and continue the
system show eula
Run the configuration wizard
command to
config setup
to
no
21